sd-card: Only add header to the results file if it’s empty
[brewing-logger:firmware.git] / config.h
2012-12-09 Philip Withnallconfig: Remove some outdated TODOs
2012-12-08 Philip Withnallheater: Fix controller to use signed fixed point rather...
2012-12-08 Philip Withnallmain: Add support for gating power to the sensors
2012-12-08 Philip Withnalllcd: Add support for gating power to the LCD
2012-12-08 Philip Withnallgas: Add support for turning the gas sensor’s heater...
2012-12-06 Philip Withnallcode: Add lots of missing documentation
2012-12-06 Philip Withnallcode: Fix SPI pin configuration
2012-12-06 Philip Withnallcode: Implement the heater controller and safety mechanisms
2012-12-03 Philip Withnallcode: Tidy up assertions and non-nulls
2012-12-02 Philip Withnallcode: Change units for gas concentration measurements
2012-11-28 Philip Withnallsimulation: Add the beginnings of a simavr-based simula...
2012-11-28 Philip Withnallcode: Fix the defined reference voltage for the MCU
2012-11-28 Philip Withnallcode: Implement periodic flushing of the Flash ROM...
2012-11-28 Philip Withnallcode: Change units for temperature
2012-11-23 Philip Withnallcode: Make humidity readings work
2012-11-23 Philip Withnallcode: Tidy up initialisation of the RTC
2012-11-23 Philip Withnallcode: Fix initialisation of the SPI bus
2012-11-21 Philip Withnallcode: Add code to read the RHT03 humidity/temperature...
2012-11-20 Philip Withnallcode: Tidy up initialisation error output a little
2012-11-16 Philip Withnallmeta: Update port mappings of various sensors
2012-11-16 Philip Withnallcode: Fix a number of compiler warnings and errors
2012-11-14 Philip Withnallcode: Implement the bulk of the main loop of the program
2012-11-09 Philip Withnallcode: Add skeleton of the code for the project